Flymo HOVER VAC User Manual download pdf (Page 5)

Adjusting the Cutting Height

HIGHEST

This symbol visible

LOWEST

This symbol visible

• THERE ARE 2 CUTTING HEIGHTS (J & K)

• Height of cut is adjusted by turning over the

cutting head.

• Disconnect from the mains electricity supply and

wait until the cutting head has stopped rotating.

Turn your product upside down.

• To Remove the Cutting Head and Fan (L)

Hold the fan firmly and twist the cutting head anti-

clockwise as illustrated. Hold the cutting head in

the centre and remove as illustrated. Hold fan in

the centre and remove as illustrated.

• Inspect for damage and clean as necessary before

replacing the fan and the cutting head.

• To Refit the Fan and the Cutting Head (M)

Replace the fan as illustrated. Replace the cutting

head, adjusting the height of cut as required. Hold

the fan firmly and twist the cutting head clockwise,

as illustrated.

• IMPORTANT

ENSURE FAN AND CUTTING HEAD ARE COR-

RECTLY LOCATED

1. Start at the edge of the lawn nearest to the power

point so the cable is laid out on the lawn you have

already cut. (N)

2. Cut your grass twice a week during the growing

season, your lawn will suffer if more than a third of

its length is cut at one time.

Do Not Overload Your Product

Using in long thick grass may cause the motor speed

to drop, you will hear a change in the motor sound. If

the motor speed drops you may overload your product

which may cause damage. When using in long thick

grass a first cut with the cutting height set higher will

help reduce the load. See Adjusting the Cutting Height.

How to Use

1 2 3 4 5 6 7 8

No comments

Flymo HOVER VAC User Manual Page 5